Like the BetaFPV HX115 LR, the Happymodel Crux3NLR also comes equipped with a built-in SPI ExpressLRS 2.4GHz receiver. This new radio communication has become extremely popular due to its excellent stability and low latency.
On top of the 115mm, carbon fiber frame has a 18650 battery bay. According to Happymodel, you can have up to 17 minutes of crossing time with a single Sony 18650 VTC6 battery.
The F4 2G4 AIO 5in1 flight controller features integrated 5A ESC, 200mW VTX, and SPI ExpressLRS 2.4GHz radio receiver. The EX1202.5 KV11500 motors are matched with 76mm 2-leaf propellers.
When it comes to long-range FPV flights, an onboard GPS positioning system is a must-have. The Happymodel Mini M8N GPS mode has a 2 meters accuracy and can work with multiple satellites provides.
Happymodel Crux3NLR highlights
- Ultralight Nano Long-Range drone with GPS;
- 115mm size carbon fiber frame (weighs only 68g without battery);
- Happymodel ELRS F4 2G4 AIO 5in1 Flight controller (FC, ESC, RX, VTX, and PDU);
- EX1202.5 KV11500 brushless motors + Gemfan 75mm propellers;
- Caddx ANT 1200tvl camera;
- Mini M8N GPS (Optional);
- Powered by a single 18650 battery (about 17min crossing time).
Technical specifications
Flight controller
- MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
- Sensor: MPU-6000(SPI connection)
- Original whoop size compatible
- Power supply: 1S battery input (DC 2.9V-4.35V)
- Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
- Built-in Betaflight OSD(SPI Control)
- Built-in 5.8G VTX
- Built-in SPI ExpressLRS 2.4GHz receiver
- Built-in 5V 1A BECFlight controller
- Firmware target: CRAZYBEEF4SX1280
Onboard 4in1 5A ESC
- MCU upgraded to EFM8BB21
- Power supply: 1S LiPo/LiPo HV
- Current: 5A continuous peak 6A (3 seconds)
- Support BLHeliSuite programmable
- Factory firmware: O_H_5_REV16_8.HEX
- Default protocol: DSHOT300
Onboard SPI ExpressLRS 2.4GHz Receiver
- Packet Rate option:25Hz/50Hz/150Hz/250Hz/500Hz
- RF Frequency:2.4GHz
- Antenna: SMD antenna
- Telemetry output Power: <12dBm
- Receiver protocol to flight controller: CRSF
- Can bind with Happymodel ES24TX, ES24TX Lite, ES24TX Slim, and DIY 2.4GHz ELRS TX modules
Onboard 5.8g VTX
- Output power: 25mw~200mw switchable
- Frequency: 40CH
- Input voltage: 3.3V 5.5V
- Current consumption: 300mA(type)
- Frequency: 5.8GHz 5bands 40 channels
- With Race band
- Smart Audio ready
Caddx ANT 1200tvl camera
- Image Sensor: 1/3″ CMOS Sensor
- Horizontal Resolution: 1200 TVL
- TV System: NTSC or PAL
- IMAGE: 16:9 or 4:3
- Synchronization: Internal
- Electronic Shutter: PAL: 1/50~100,000; NTSC: 1/60~100,000
S/N Ratio : >52dB (AGC OFF) - Video Output: CVBS
- Lens: 1.8mm
- Min. Illumination: 0.001Lux@F1.2
- Auto Gain Control: YES
- BLC: YES
- WDR: Global WDR and DNR: 3D DNR
Happymodel Mini M8N GPS (Optional)
- Chip Model: Mini M8N GPS
- GPS+SBAS or GPS+GLONASS+SBAS
- Position Accuracy: 2.0 m CEP
- Sensitivity2 Tracking & Nav: –167 dBm
- Cold starts: –148 dBm
- Hot starts: –156 dBm
- Update rate: 5HZ Default, up to 10HZ
- Baudrate: 57600
- Cold start waiting time: 3~5minutes
- Warm start waiting time: 0.5~1.5minutes
Demo flight with the new Crux3NLR drone
