The newly released Holybro Kakute H7 V1.3 flight controller supports 2 to 8S LIPO batteries and is intended for classic four-motor drones and professional octocopters. It has nine PWM outputs (2x4in1ESC and LED), six UART ports (UART2 is used for Bluetooth telemetry), and a dedicated HD digital port for DJI O3 Air Unit and other compatible VTXs.
According to HolyBro, the Kakute H7 incorporates the best features of its F7 predecessor and further improves on hardware components and layout. With the additional integrated Bluetooth chip onboard, you can perform Betaflight configuration and tune wirelessly on your phone with the SpeedyBee Android & IOS App. The built-in 5V 2A and 9V 3A BECs can power various accessories, including high-power VTXs and cameras. Furthermore, it has a MicroSD Card slot for virtually unlimited Blackbox data logging.
The integrated BetaFlight OSD makes it easy to display important information on your FPV display, like battery voltage, flight time, warnings, RSSI, smart audio features, and more. It is also ready for autonomous flight with the onboard barometer. There are LED & buzzer pads, I2C pads (SDA & SCL) for external GPS/Magnetometers.
Technical Specification:
- MCU – STM32H743 32-bit processor running at 480 MHz
- Professional underfill epoxy for mechanical reinforcement
- IMU – MPU6000
- Barometer – BMP280
- OSD – AT7456E
- Onboard Bluetooth chip – ESP32-C3
- SpeedyBee IOS & Android App Compatible
- Note: The Bluetooth onboard is set to automatically turn off when the flight controller is unlocked (arm) and turn on automatically when the flight controller is locked (disarm) in Betaflight
- 6x UARTs (1,2,3,4,6,7; UART2 is used for Bluetooth telemetry)
- 9x PWM Outputs (8 Motor Output, 1 LED)
- 2x JST-SH1.0 8pin ESC port (4in1 ESCs, x8/Octocopter compatible)
- 1x JST-SH1.0 6pin VTX port (For HD Systems like Caddx Vista & Air Unit)
- Battery input voltage: 2S – 8S
- BEC 5V 2A BEC 9V 3A
- USB Type-C
- 30.5 x 30.5mm/Φ4mm mounting pattern with Φ3mm Grommets
- Dimension – 35x35mm
- Weight – 8g
Kakute H7 FC: Firmware compatibility
- BetaFlight v4.2.11 and above
- INAV 4.0.0 & above SD card support added since 4.1.0.
- ArduPilot 4.2.0 & above
Box Content
- 1x Flight controller board
- 4x M3 Silicon Grommets
- 2x JST-SH1.0_8pin 150mm Cable (For ESCs)
- 2x JST-SH1.0_6pin 80mm & 150mm Cable (For DJI Air Unit)
- 1x JST-SH1.0_6pin Colored Silicon 150mm Cable (For Caddx HD System and other VTX)
