SpeedyBee F745 35A BLS claims to be the world’s first AIO flight controller with built-in wireless connectivity (Bluetooth and WiFi). It allows changing everything right on the flight field using your mobile phone. You can configure a new radio receiver, motor layout, PIDs, and other things.
The flight controller measures 36.5×36.5×7 and it has a 25.5×25.5 mounting pattern. Weighting just 10 grams it is perfect to build FPV drones that weigh less than 250 grams. It supports PPM, Crossfire, and ELRS radio receivers. Thanks to the 4 UART ports it can be equipped with GPS and other types of sensors. Another great feature is the onboard DJI Air Unit plug.
The integrated 35A ESC has powerful and durable Toshiba MOSFETs and supports full BLHeli_S configuration.
SpeedyBee F745 AIO FC technical specifications
| Power Input | 3S – 6S Lipo |
| Mounting | 25.5 x 25.5mm, 3mm hole diameter |
| Dimension | 36.5mm(L) x 36.5mm(W) x 7mm(H), recommended for quads at 3.5″ or above |
| Weight | 10.1g |
| FC | |
| MCU | STM32F745 |
| IMU(Gyro) | MPU6000 |
| USB Connection | Need to solder a USB TYPE-C module to D+, D-, GND pads. |
| Barometer | BMP280 |
| OSD | Supported |
| BLE Bluetooth | Supported. Used for parameter configuration |
| Flash FC Firmware Wirelessly | Supported |
| Download/Analyze Blackbox | Supported |
| DJI Air Unit 6-pin Connector | Built-in |
| Flash(for BlackBox) | 8MB |
| Current Sensor | Supported. Scale=256 |
| BetaFlight Camera Control Pad | Yes (CC pad) |
| 5V Output | 4 groups of 5V output. The total current load is 2.5A. |
| 9V Output | None |
| 3.3V Output | Supported. Up to 500mA current load. |
| ESC Signal Pads | M1 – M4 |
| UART ports | Full UART * 4(UART1, UART2, UART3, UART4) |
| ESC Telemetry UART | None |
| I2C | Supported. |
| LED Pad | Used for WS2812 LED |
| Buzzer | BZ+ and BZ- pad used for 5V Buzzer |
| BOOT Button | Used to enter DFU mode |
| RSSI Input | Not supported |
| SmartPort | Use any TX pad of UART for the SmartPort feature. |
| Supported Flight Controller | BetaFlight(Default) |
| Firmware Target Name | SPEEDYBEE F745AIO |
| ESC | |
| Power Input | 3-6S LiPo |
| Continuous Current | 35A * 4 |
| Burst Current | 45A(5S) |
| ESC Protocol | DSHOT300/600 |
| Power Output | VBAT |
| Current Sensor | Supported(Sacle=256) |
| Firmware | BLHeli_S JH40 |
